UHU Plus Endfest 300 90min Epoxy 2x15ml 33g - 300kg Capacity UHU41917
£8.19

Shipping from:
£4.99

Brand:  UHU
Part No: UHU41917
Barcode: 4026700456400
Availability : Sold Out !

PROPERTIES
Super-strong (up to 170 kg/cm²)
Resistant to temperatures between -40°C and +100°C
Filling
Water resistant
Chemical resistant
Paintable
Technical documentation
Back to top
APPLICATION

SUITABLE FOR:
Suitable for repairs to metal, ceramics, porcelain, crystal, glass, ivory, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex®).

HANDLING

BEFORE USE:
Working conditions
Only apply at temperatures between +5°C and +35°C. Product cures by mixing the resin and the hardener.

Personal safety
Preferably wear gloves.

Surface requirements
The surface must be dry, clean and free of dust and grease.

Preliminary surface treatment
Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper).

Tools
Mix the components by means of the supplied mixing bowl and spatula.

DURING USE:
Directions for use
Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a spatula until a mixture is obtained with a homogeneous colour. Apply the mixture, which at room temperature (+20°C) remains toolable for about 1.5 hours, as a thin layer on one of the two materials. Join the materials and keep them in place for 7 hours. Be careful not to move the parts before the adhesive has cured. Resin and hardener must not come into contact with each other unless for usage.

Advice
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

Points of attention
Close well after use. For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5°C.

AFTER USE:
Stains/residue
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions
Store in tightly closed packaging in a dry, cool and frost-free place.

Please read the safety notices on the packaging. 

Open time: 

Depends on quantity used and ambient temperature (approx. 2 hours at room temperature). 

Setting: 

The setting time depends on the temperature; final strength can be increased by applying heat (not over 200°C – see table).